1. The hanging single side column connecting footing is composed of three parts: column, footing and front baffle hanger. Before installation, check whether the parts are complete and the size is correct. After the check, install the footing adjusting screw, and adjust the height of the footing screw according to the flatness of the ground.

2. After the column is installed, the back plate can be installed. The installation back plate is generally installed from bottom to top. Insert the legs on both sides of the back plate symmetrically into the inner long hole on the column. The rest of the back plates are installed in the same way.

3. The installation method of the front baffle is the same as that of the back plate. Insert the hanging leg of the front baffle symmetrically into the inner long hole on the hanging piece of the front baffle of the footing.

4. Next, install the bottom plate of the lower layer, and put the bottom plate into the groove on the footing. Note that the inner side of the layer plate should be close to the back plate, and there is no obvious gap between the back plates.

5. The installation position of the corbel is determined by the number of shelves. After determining the number of shelves, insert the corbel into the inner long hole on the column (the corbel and the back plate are placed in the same hole), and the corbel on both sides of the column should also be horizontal.

6. After the corbel is installed, place the laminates on the corbel on both sides stably to keep fit with the backplane without gaps. The same method is used for other laminates.